Last viewed - RATtreks.com

Last viewed

772 viewsFront bumper lower part trimmed May 14, 2026 at 04:41 PM

798 viewsMay 14, 2026 at 04:41 PM

847 viewsGranny`s Kitchen May 14, 2026 at 04:41 PM

754 viewsTaken 12-7-2016May 14, 2026 at 04:41 PM

883 viewsMay 14, 2026 at 04:41 PM

833 viewsThe new rims/tires I am going to use after it is lifted May 14, 2026 at 04:41 PM

838 viewsTyler high above me as I am in the Little Rat Crack May 14, 2026 at 04:41 PM

781 viewsMay 14, 2026 at 04:41 PM

809 viewsDriver side trimmed May 14, 2026 at 04:41 PM

808 viewsGranny`s Kitchen May 14, 2026 at 04:41 PM

783 viewsFirst view of the area beside the wall called Fish Face Rock May 14, 2026 at 04:41 PM

691 viewsTaken 11-14-2015May 14, 2026 at 04:41 PM

728 viewsTaken 11-28-2015May 14, 2026 at 04:41 PM

715 viewsPinch weld ground back a lot May 14, 2026 at 04:41 PM

700 viewsMarked the trim for cutting (always go big and then sand it down gradually to get the perfect fit, once its too small you`re screwed !! ) May 14, 2026 at 04:41 PM

787 viewsMay 14, 2026 at 04:41 PM

757 viewsI reused the cut pieces and riveted them back to the trimmed bumper corners so I would have a nice edge instead of a narrow cut one and a way to mount the inner fenders back to it. I would epoxy glue those later in this process for stability as those rivets would never last by themselves under off roading conditions. May 14, 2026 at 04:41 PM

891 viewsTyler takes a siesta atop granny`s Kitchen while john and Badger get busy taking pics of the falls and potholes there May 14, 2026 at 04:41 PM

737 viewsMay 14, 2026 at 04:41 PM

777 viewsTaken 12-13-2016May 14, 2026 at 04:41 PM

785 viewsMay 14, 2026 at 04:41 PM

708 viewsYou can see how well the inner fender worked out in the front and that shiny bolt is where I had to move it forward 2 inches from the black plastic clip you also see in there May 14, 2026 at 04:41 PM