1006 viewsNew isolators and spacer installed
|
|
1006 viewssanded and ready for priming
|
|
1006 viewsAFTER painting the trim black ! And a new black grille,,
|
|
1003 viewsremoving the lower coil sporing isolator from rear coil . Rusted but nowhere near as bad as front. Cleaned and sanded well and painted with POR.
|
|
1002 viewsSway bar re-attached
|
|
1001 viewsFirst I cut out a large slot in the lower end of the bumper cover
|
|
1001 viewsNow to cut the driver side bumper cover
|
|
1000 viewsI sanded it down and prepped it for primer
|
|
996 viewsYou can see how well the inner fender worked out in the front and that shiny bolt is where I had to move it forward 2 inches from the black plastic clip you also see in there
|
|
995 viewsnew blots to mount the bottom of the bumper cover. There are 4 down there and this one was missing almost all.
|
|
995 viewsTyler on the rope taking down trees.
|
|
994 viewsPass side trimmed
|
|
991 viewsTyler helping me to dig out an old gutter drain to replace with new plastic pipe.
|
|
989 viewsinner fender working out well on pass side
|
|
989 viewsTyler working his way down the tree.
|
|
988 viewsNow to trim the back of the front fenders. First thing, remove the trim.
|
|
988 viewsAfter a couple of coats of good black trim paint WITH flex additive
|
|
988 viewsAFTER painting the trim black ! And a new black grille,,
|
|
987 viewsTyler helping to bust through the sidewalk so we can remove the old clay gutter drain pipe.
|
|
986 viewsNew isolators and spacer installed
|
|
986 viewsThe amount of tools needed for this job.
|
|
986 viewsAFTER !
|
|
986 viewsThese are the rims/tires I am wishing to put on after the lift
|
|
986 viewsAdded some new fluid to the transfer case as well since you lose some when removing the yoke.
|
|
| 268 files on 12 page(s) |
 |
|
|
|
|
7 | |
|
|
|
|
