1040 viewsYou can see the new rubber isolator at top
|
|
1039 viewsTyler working to top the tree
|
|
1038 viewsAll folded over and also the lower part now cut and folded as well
|
|
1037 viewsTrimmed the back edge as well just like the other side.
|
|
1036 viewsGonna be trimming this
|
|
1034 viewsRear differential drain plug (if you can call that rubber pos that) leaking so I replaced it with new one and topped off rear end grease as axle grease seals were leaking into the breaks. I will be rebuilding the rear end soon as it has been roaring since I bought it.
|
|
1034 viewsCustom fitting the end cap
|
|
1034 viewstop isolator on rear coil ,, badly squished and worn
|
|
1033 viewsreplacing the driveshaft required removing and replacing both yokes (one on front differential and one on front of transfer case)
|
|
1033 viewsYep looks good,
|
|
1030 viewsEnd cap fitting nicely !
|
|
1030 viewsTaping it up to paint the trim black
|
|
1030 viewsTyler working his way down the tree.
|
|
1029 viewsFront part of pass side inner fender looking good after mounting to bumper cover
|
|
1027 viewsPainted with POR (since this one on driver side is so bad, I will install a coil spring retainer just for piece of mind)
|
|
1027 viewsTyler gnome poses atop of a large Maple tree we have been cutting in the yard.
|
|
1026 viewsFactory height (actually a little under due to deteriorated coil spring isolators which are also being replaced)
|
|
1026 viewsFront bumper lower part trimmed
|
|
1025 viewsnew oil seal installed on transfer case
|
|
1024 viewsOld Rzeppa/Rzeppa style front driveshaft removed
|
|
1024 viewsLower bumper section removed
|
|
1023 viewsRemoving rear coils
|
|
1022 viewsnew oil seal installed on front diff
|
|
1021 viewsI custom trimmed the end cap as well so it would fit back on and look like it came that way.
|
|
| 268 files on 12 page(s) |
 |
|
|
5 | |
|
|
|
|
|
|
