RATtreks.com - Images of RATventures

Home > Misc. > 1999 Jeep WJ pics

Most viewed - 1999 Jeep WJ pics
0722.jpg
1046 viewsJacking up one side as far as it will go to give room to get the coil back in with new rubbers and the spacer.
0774.jpg
1046 viewsNew rubber plug replaced and grease topped off.
0725.jpg
1045 viewsSpacer in, now ready to put coil back in. Lots of room on first one.
0728.jpg
1043 viewsYou can see the new rubber isolator at top
0861.jpg
1042 viewsTrimmed the back edge as well just like the other side.
0892.jpg
1041 viewsAll folded over and also the lower part now cut and folded as well
0655.jpg
1039 viewsreplacing the driveshaft required removing and replacing both yokes (one on front differential and one on front of transfer case)
0798.jpg
1039 viewsGonna be trimming this
0703.jpg
1039 viewstop isolator on rear coil ,, badly squished and worn
0923.jpg
1038 viewsCustom fitting the end cap
0770.jpg
1037 viewsRear differential drain plug (if you can call that rubber pos that) leaking so I replaced it with new one and topped off rear end grease as axle grease seals were leaking into the breaks. I will be rebuilding the rear end soon as it has been roaring since I bought it.
0921.jpg
1037 viewsYep looks good,
1008.jpg
1034 viewsTaping it up to paint the trim black
0630.jpg
1033 viewsPainted with POR (since this one on driver side is so bad, I will install a coil spring retainer just for piece of mind)
0924.jpg
1033 viewsEnd cap fitting nicely !
0935.jpg
1033 viewsFront part of pass side inner fender looking good after mounting to bumper cover
0670.jpg
1031 viewsnew oil seal installed on transfer case
0863.jpg
1030 viewsLower bumper section removed
0877.jpg
1029 viewsFront bumper lower part trimmed
0586.jpg
1028 viewsFactory height (actually a little under due to deteriorated coil spring isolators which are also being replaced)
0648.jpg
1028 viewsOld Rzeppa/Rzeppa style front driveshaft removed
0681.jpg
1027 viewsnew oil seal installed on front diff
0702.jpg
1027 viewsRemoving rear coils
0898.jpg
1025 viewsI custom trimmed the end cap as well so it would fit back on and look like it came that way.
160 files on 7 page(s) 2